Panasonic VB-44210G User Manual page 191

Section 700 - Operation
7. Press the HOLD key.
To assign System Speed Dial numbers to One-Touch keys:
1. Press the ON/OFF key.
2. Press the PROG key.
3. Press the One-Touch key to be programmed.
4. Press the AUTO key.
5. Enter the System Speed Dial Number to be programmed.
6. Press the HOLD key.
7. Press the ON/OFF key.
To chain two to five System Speed Dial numbers to a single One-
Touch key:
1. Press the ON/OFF key.
2. Press the PROG key.
3. Press the One-Touch key to be programmed.
4. Press the AUTO key.
5. Enter the System Speed Dial number for the pooled trunk access code.
6. If a pause is required, press the REDIAL key.
DBS-2.3/9.2-700
• The phone issues intercom dial tone.
• The ON/OFF LED lights.
The ON/OFF LED goes off.
• The phone issues intercom dial tone.
• The ON/OFF LED lights.
[This preprogrammed System Speed Dial must contain a C (CONF)
followed by 9, 1-6 for pooled trunk access groups 9, 81-86).]
This inserts a pause between the access code and the telephone number.
When REDIAL is pressed, an "R" displays. If viewed later, a "P"
displays.
DBS Manual - Revised April 2000
Chapter 4. Key Telephone Features
4-75