Table of Contents
Advertisement
20 October 2010
TM-006
Fault Code TM-006, indicates that the Trim knife motor (TM-M2) has a Open circuit.
Initial Actions
Check fuse F2 on Transformer.
Procedure
Disconnect the motor plug M2. Enter Service mode and start Trim knife motor (TM-M2) in check motors. Measure between the
orange wire M2 and the violet wire M2 (PWM 36 and ground). The voltage is approximately 22 VDC?
Y
N
Disconnect plug B.P3 from PCB "A". Measure between J3-6 and J3-7 (PWM 36 and ground). The voltage is
approximately 22 VDC?
Y
N
Replace PCB "A".
Replace wire Harness.
Replace motor TM-M2.
TM-007
Fault Code TM-007, indicates that the Stop gate motor (TM-M3) had a Cycle time out.
Initial Actions
Check fuse F2 on Transformer.
Enter the Service mode and select Stop gate motor (TM-M3) in check motors.
Make sure that the Paper stop gate home position sensor (TM-Q7) is installed correctly.
Procedure
Enter the Service mode and select Paper stop gate home position sensor (TM-Q7) in check sensors. The Paper stop gate
home position sensor indicates :1 when the sensor is blocked, and :0 when the sensor is unblocked?
Y
N
1. Replace sensor TM-Q7.
2. Disconnect plug B.P13 from PCB "A". Measure between J13-7 and J13-9 (5V and ground). The voltage is
approximately 5 VDC?
Y
N
Replace PCB "A".
Disconnect plug from sensor TM-Q7. Check wires for Continuity / Short circuit from the white wire Q7 to
B:P13-8. Is there Continuity and no Short circuit?
Y
N
Replace wire Harness.
Connect plug B.P13 to PCB "A". Measure between the red wire Q7 and the black wire Q7 (5V and ground). The
voltage is approximately 5 VDC?
Y
N
Replace wire Harness.
Replace PCB "A".
Are you able to move the Stop gate up and down without it interfering with anything?
Y
N
Make sure that the Stop gate does not interferes with the "Deck plate". Adjust if necessary (
1. Check the allen screw on the "cam" to TM-M3.
2. Replace motor TM-M3.
FAULT CODE DESCRIPTIONS
TR-4-5
TM 3.2.10).
Advertisement
Table of Contents
