Transport Belt Sensor Q4 - Sharp MX-TMX1 Service Manual

20 October 2010

3.2.5 TRANSPORT BELT SENSOR Q4

Removal
1. Remove Rear cover (
2. Remove connector [A] (
3. Remove nut and screw [B] (
4. Remove bracket [C].
5. Squeeze the barbs of the sensor to remove.
Replacement
1. Reverse the removal procedure
NOTE: When tightening nut/screw make sure there is a space between en-
coder disc and sensor.
2. Enter service program mode and start the belts (motor M1). Check speed (m/
s) is registered (
3. If no, or erratic speed, loosen screw/nut [B] (
4. Reposition sensor to obtain correct speed registration.
5. Tighten screw/nut [B] (
3.1.1).
x1).
x1, x1).
Service Manual MX-BMX1: 5.1.1, 5.1.2).
x1, x1).
TR-3-15
[C]
[A]
[B]
x1, x1).
AREA C