Trim Knife - Sharp MX-TMX1 Service Manual

AREA C

3.2.8 TRIM KNIFE

WARNING
Stay clear from upper knife. The knife edge may cause serious injuries.
Place the safety block [A] between lower knife and upper knife beam. Keep
the safety block in that position as much time as possible throughout this
procedure.
Removal
1. Remove the belt stacker.
2. Undock the Trimmer.
3. Latch the compressing bracket in upper position.
4. Remove the infeed cover (
5. Remove protection cover (
Removal Upper knife
1. Remove screws [B] (
2. Remove knife protection plate [C].
3. Move transport protection from the new to the old knife or use the transport
protection attached behind the front cover.
4. Remove the e-clip [D] from the middle plunger, to release the Set clamp (
x1).
5. Remove screws [E] and cup spring washers (
Note: When removing screws [E] the nuts [G] will fall down through the cut-out
in bottom of knife beam.
Removal Lower knife
1. Remove screws [H] (
2. Remove screws [I] and cup spring washers (
[A]
3.1.4).
3.1.9).
x3).
x4).
TR-3-18
[D]
[B]
[G]
[E]
[F]
[C]
Upper knife
x6).
x2).
20 October 2010
Lower knife