Table of Contents
Advertisement
20 October 2010
3.2.20 INFEED BELTS
[E]
[B]
[A]
Removal
1.
Undock the Trimmer.
2.
Remove Infeed cover (
3.
Remove Front and Rear cover (
4.
Unhook Transmission chain [E] from sprocket [F].
NOTE: Unhooking chain from outfeed shaft sprockets first to gain more slack.
5.
Unhook Springs [A] on both ends of the shaft (x2).
6.
Remove screws [B] on both ends of the shaft (
7.
Remove Plastic retaining clips [G] (x8).
8.
Remove Belts [D] (x4) from Lever shaft [H].
NOTE: Move the belts to one end and the lever shaft to the opposite end.
9. Remove e-clip [C] and slide flange bushing towards the center of the shaft.
(
x1)
10. Tilt the shaft out through the cut-out in the side frame on that end to
remove the Belts [D] (x4).
Replacement
1.
Reverse the removal procedure.
Adjustment
1.
Loosen nuts [B] (
2.
Place a piece of paper (80 gsm) between the two center belts and the ball
bearings.
3.
Pull the sheet a little, by each of the center belts to verify even pressure.
4.
Unskew shaft until even pressure is obtained and tighten nuts [B] (
[G]
[F]
3.1.4).
3.1.1).
x2) slightly.
TR-3-35
[D]
[H]
x2) .
AREA C
[C]
x2).
Advertisement
Table of Contents
