Control Switch S3 - Sharp MX-TMX1 Service Manual

20 October 2010

3.2.3 CONTROL SWITCH S3

[B]
Removal
1. Remove Rear cover (
2. Remove connector [B] (
3. Remove screw [A] (
Replacement
1. Reverse the removal procedure.
Adjustment
1. Lift the compressing bracket.
2. Make sure the Switch activates approximately 10 mm from where the com-
pressing bracket latches in the upper position.
3. To adjust, loosen screws [A] (
4. Reposition switch to obtain adjustment.
5. Tighten screws [A] (
3.1.1).
X2).
x2).
x2 ).
x2 ).
TR-3-13
AREA C
[A]