20 October 2010
Replacement Upper knife
1.
Move transport protection from the old to the new knife.
2.
Clean and apply grease on guide bars [J] and side guides [K].
3.
Fit upper knife onto guide bars [J].
Apply grease on the cup spring washers [F] closest to the knife.
Mount screws [E] with nuts [G] (
Note: Make sure each screw has 7 cup spring washers placed accord-
ing to figure.
4.
Remove transport protection and mount
it on the old knife.
5.
Mount knife protection plate [C].
6.
Mount the set clamp in position with
e-clip [D] (
x1) .
Replacement Lower knife
1.
Place the lower knife onto the lower knife
beam.
2.
Apply grease on both washers.
3.
Mount screws [I] (
washers.
4.
Mount screws [H] (
5
Adjustment
1.
Turn screws [E] so there is no tension and no play between cup spring wash-
ers and upper knife.
2.
Then turn screws [E] one revolution clockwise each.
3.
Loosen nuts [L] (
4.
Turn screws [M] (
5.
Loosen screws [I] & [H] (
6.
Push the Lower knife against the bracket [N].
x6,
x2) and cup spring
x4).
[I]
[H]
1
3
4
[L]
[M]
x3)
x3) counter clockwise until they passes edge [N].
x6).
TR-3-19
x6).
[D]
[O]
[B]
[K]
[G]
[E]
[F]
[J]
[C]
2
6
[N]
AREA C
[N] [L]
[M]