Advertisement
3. Press the IMPORT/EXPORT menu key to display the IMPORT/EXPORT screen.
4. Press the EXPORT DATA menu key to display the EXPORT DATA screen. The status bar in the
center of the screen displays the message READY TO TRANSFER to show that the transfer is
ready to start.
5. Before transferring, check the communication link between the two units by pressing the TEST
COMM key. If the status bar now displays the message REMOTE LINK OK, you may begin to
transfer waypoints.
6. To move waypoints and routes from the master unit into the other unit, press the START key.
The status bar displays the message TRANSFERRING and updates every second with the num-
ber of waypoints and routes sent compared to the total quantity to be sent. The progress bar,
located below the status bar, graphically shows the percentage completed.
If there's a problem with the transfer process, the following messages may appear:
If the other unit is off-line, the master unit displays the dialog-box message TRANSFER
•
ABORTED BY COMMUNICATION TIMEOUT and the status-bar message COMMUNICATION
ERROR.
•
If the master unit doesn't contain any waypoints and routes, the master unit displays the
dialog-box message NO WAYPTS OR ROUTES TO TRANSFER and the status-bar message NO
TRANSFER DONE.
6 of 8
941/95x GPS Chart Navigators
Waypoint/Route Sharing & Color Palette Selection Operator Instructions Rev. C
Advertisement
