Advertisement
If there's no problem with the transfer process, the master unit's status bar displays the message
TRANSFER COMPLETE when done. You can now press any key to resume other operations.
Moving waypoints and routes from a master unit (export)
When you move waypoints from unit 1 (the designated master) into unit 2, the entire contents of unit
1 are exported into unit 2. Also, if any waypoint or route name matches exist, the waypoints or
routes from unit 1 will overwrite the waypoints or routes already in unit 2.
1. Select the unit you'd like to use as the "master. " Remember: You can use either of two units as
the master because both units are capable of importing or exporting waypoints and routes.
2. At the "master" unit, press the WAYPTS/ROUTES key to display the WAYPTS AND ROUTES
screen.
Waypoint/Route Sharing & Color Palette Selection Operator Instructions, Rev. C
941/951x GPS Chart Navigators
If you press any function key on the master unit during the
transfer, the error message
HIT
will be displayed, the process will be aborted, and the
master unit will display the particular screen accessed by that
function keypress. You can press any key on the other unit,
however, without interrupting the transfer process.
To purposely stop the transfer at any time, press the
STOP
key. If you press the
TRANSFER ABORTED BY KEY HIT
dialog-box message
and the status bar displays the message
ABORTED
. Waypoints and routes transferred up to that point
are in the receiving unit (be aware that a particular route may
not contain all of its waypoints due to the transfer interruption).
START
Press the
key again to re-start the entire transfer pro-
cess (this means that all waypoints and routes, not just the
ones already in the receiving unit and the ones left to be trans-
ferred, are re-transferred).
NOTE:
TRANSFER ABORTED BY KEY
key, the master unit displays the
TRANSFER
STOP
,
5 of 8
Advertisement
