Advertisement
3. Press the IMPORT/EXPORT menu key to display the IMPORT/EXPORT screen.
4. Press the IMPORT DATA menu key to display the IMPORT DATA screen. The status bar in the
center of the screen displays the message READY TO TRANSFER to show that the transfer is
ready to start.
5. Before transferring, check the communication link between the two units by pressing the TEST
COMM key. The status bar should display the message REMOTE LINK OK.
6. To move waypoints and routes into this master unit from the other unit, press the START key.
The status bar displays the message TRANSFERRING and updates every second with the num-
ber of waypoints and routes already received against the total quantity to be received. The
progress bar, located below the status bar, graphically displays the percentage completed.
If there's a problem with the transfer process, the following messages may appear:
•
If the other unit is off-line, the master unit displays the dialog-box message COULDN'T GET
REMOTE WAYPT/ROUTE COUNT and the status-bar message COMMUNICATION ERROR.
•
If the other unit doesn't contain any waypoints and routes, the master unit displays the dia-
log-box message NO WAYPTS OR ROUTES TO TRANSFER and the status-bar message NO
TRANSFER DONE.
•
If the master unit is completely full of waypoints and routes (no more room available), the
master unit displays the dialog-box message LOCAL UNIT STATUS ERROR [002] DATABASE
FULL and the status-bar message COMMUNICATION ERROR.
4 of 8
941/95x GPS Chart Navigators
Waypoint/Route Sharing & Color Palette Selection Operator Instructions Rev. C
Advertisement
