Table of Contents
Advertisement
Chapter 2: Mount and Install the Smart-hopping 2.0 Access Point 1.4 GHz
2. Connect the Access Point to the Smart-hopping Sync Unit only when appropriate as
part of the overall Smart-hopping installation.
a) After initially connecting and powering the Access Point, verify that the two status
Note If after connecting and powering the Access Point, its LEDs are lit red and the Remote Antenna
LEDs do not light at all, open the APC web interface, click System in the View Device tree, click
Configure and then select the Advanced tab. Verify that the Allow new APs to be added
automatically option is set to True. This option must be set to True for the Access Point and Remote
Antenna LEDs to light properly.
b) Reboot the Access Point.
c) For instructions on the Access Point startup sequence, see page 2-43.
2-42
UTP Cable Connectors
to Remote Antennas (2 & 1)
Coaxial Cable Connectors
to Remote Antennas (2 & 1)
LEDs on each of its connected Remote Antennas are lit. You can verify this by
viewing the Access Point status page presented in the APC web interface.
The Access Point and its connected Remote Antennas ought to be listed in the APC
web interface. Press F5 to refresh the web interface display if the Access Point and
RAs are not listed.
DRAFT - 03 JUN 2022 13:32
Smart-hopping Access Point
Ethernet Interface to
Smart-hopping Sync Unit
Advertisement
Table of Contents
