Philips Smart-hopping 2.0 Installation Manual page 39

Fixed Mounting the Smart-hopping Access Point to a Wall (With Cosmetic Cover)
8
9
Smart-hopping 2.0 Access Point 1.4 GHz Installation Guide
Pull the cables out from the wall
(through the grommets) and connect
them to the appropriate jacks on the
Access Point.
Connect the Ethernet (network
connection) cable to the LAN port on
the Access Point. This provides power
to the Access Point and lights up the
LEDs on the front of the Access Point (if
the other end of the Ethernet cable is
connected to a Power over Ethernet
Switch that is powered on).
If using two Remote Antennas,
perform this step on both the RA1 and
RA2 connectors on the Access Point:
• Connect the Coaxial cables (from the
same side of the strand) to the RA coaxial
connector.
• b) Connect the RJ-45 connector to the RA
RJ-45 connector.
While holding the Access Point chassis
and attached plastic cover, fit the holes
in the back of the Access Point chassis
over the keyhole screws that protrude
from the mounting bracket. Slide the
Access Point chassis down so that the
screw heads are securely in the grooves
in the back of the Access Point chassis.
You hear a click noise when the Access
Point is securely placed in the
mounting bracket.
DRAFT - 03 JUN 2022 13:32
2-11