Philips Smart-hopping 2.0 Installation Manual page 23

Access point 1.4 ghz
Table of Contents

Advertisement

Specification
Time slots allocated for wireless clients
• No Remote Antennas connected
• One Remote Antenna connected
• Two Remote Antennas connected
• Time slots allocated for roaming
Advanced Mode (4 channel mode):
Channel spacing
Modulation
Power output
Antenna gain
Time slot types supported
Total time slots available
Time slots allocated for wireless clients
• No Remote Antennas connected
Time slots allocated for roaming
Electrical Installation:
Fire Safety
Interface Connections:
LAN Input (Data): One-port Ethernet 10/
100 Base-T (100-Mbps connections must be
Full Duplex)
LAN Cable to Network Switch
Remote Antenna UTP Cable Connectors
Remote Antenna 75 Ohm Coaxial Cable
Connectors
Smart-hopping 2.0 Access Point 1.4 GHz Installation Guide
Table 1-3: Smart-hopping 2.0 Access Point 1.4 GHz Specifications
18
9 (and 9 for the Remote Antenna)
6 (and 6 for each Remote Antenna)
14
1.728 MHz
PI/2-DBPSK, PI/4-DQPSK
14 (±1.5) dBm (17.8 mW to 35.5 mW) into Antenna Load (2:1 VSWR
maximum)
2 dBi
Single
32
18
14
Smart-hopping 2.0 Access Point 1.4 GHz are Listed for use within "Other
Spaces Used for Environmental Air (Plenum)" per NFPA70: 2011, Article
300.22.
Note: The term "plenum" as used in Article 300.22 Section C correlates with
the use of the term "plenum" in NFPA 90A-2009, Standard for the Installation
of Air-Conditioning and Ventilating Systems, and other mechanical codes
where the plenum is used for return air purposes, as well as some other air-
handling spaces. The area above dropped ceilings is an example of plenum
space.
RJ45 Female Socket
CAT-5e (or higher) with a length of up to 100 m (328 ft.).
Two RJ45 Female Socket Connectors are provided to connect the UTP cables
with 5 V DC power, Transmit and Receive control signals, and Antenna
Diversity signals to the remote Antennas are carried. Connectors are
protected against damage from unexpected connection to LAN with PoE.
Two standard 75-Ohm connectors are provided for the coaxial cables on
which RF and DC sense signals are carried to the Remote Antenna.
DRAFT - 03 JUN 2022 13:32
Specifications
Value
1-11

Advertisement

Table of Contents
loading

This manual is also suitable for:

867216

Table of Contents