Philips Smart-hopping 2.0 Installation Manual page 47

7
8
9
Smart-hopping 2.0 Access Point 1.4 GHz Installation Guide
To secure the nuts, place a push nut
over each of the bolts and push down
until it sits on top of each nut.
You can do this by hand or use a tool,
such as pliers or an open-ended
wrench.
Connect the Ethernet (network
connection) cable to the LAN port on
the Access Point. This provides power
to the Access Point and lights up the
LEDs on the front of the Access Point (if
other end of Ethernet cable is
connected to a powered
Synchronization Unit).
If using two Remote Antennas
(perform this step on both the RA1 and
RA2 connectors on the Access Point:
• Connect the Coaxial cables (from the
same side of the strand) to the RA
coaxial connector.
• Connect the RJ-45 connector to the RA
RJ-45 connector.
Place the tile into the ceiling.
Replace other adjacent ceiling tiles, if
necessary.
DRAFT - 03 JUN 2022 13:32
Flush Ceiling Mount (with Cosmetic Ring)
Push Nut
2-19