Fixed Mounting The Smart-Hopping Access Point To A Wall (With Cosmetic Cover) - Philips Smart-hopping 2.0 Installation Manual

4
5
Smart-hopping 2.0 Access Point 1.4 GHz Installation Guide
Fixed Mounting the Smart-hopping Access Point to a Wall
Screw a supplied #6 x 1 1/4 inch self-
tapping screw through each hole in the
mounting bracket and into each screw
anchor (or pilot hole).
Pull the cables out from the ceiling and
connect them to the appropriate jacks
on the Access Point.
Connect the Ethernet (network
connection) cable to the LAN port on
the Access Point. This provides power
to the Access Point and lights up the
LEDs on the front of the Access Point (if
the other end of the Ethernet cable is
connected to a Power over Ethernet
Switch that is powered on).
If using two Remote Antennas,
perform this step on both the RA1 and
RA2 connectors on the Access Point:
• Connect the Coaxial cables (from the
same side of the strand) to the RA coaxial
connector.
• b) Connect the RJ-45 connector to the RA
RJ-45 connector.
DRAFT - 03 JUN 2022 13:32
2-5