Philips Smart-hopping 2.0 Installation Manual page 65

4
5
Smart-hopping 2.0 Access Point 1.4 GHz Installation Guide
Connect the Mounting Bracket and
Rail to the ceiling tile:
• Pick up the Mounting Bracket and orient
it so that the rectangular cutout on the
Bracket is in the same direction as the
Cable Access arrows on the Mounting
Rail.
• With the adapter plates adhered to the
Mounting Bracket, insert the 4 bolts
from the finished side of the tile through
the four 1/4-inch holes in the ceiling tile
and through the B holes in the Mounting
Rail.
Secure the Mounting Bracket and
Mounting Rail to the tile:
• Place an M6 x 1 nut on each of the bolts
from the adapter plate that stick
through the holes in the mounting rail.
• Tighten the nuts and make sure you do
not over tighten the nuts, which may
break the tile.
DRAFT - 03 JUN 2022 13:32
Below Ceiling Mount (with Cosmetic Cover)
2-37