Mount The Hardware - Philips Smart-hopping 2.0 Installation Manual

Chapter 2: Mount and Install the Smart-hopping 2.0 Access Point 1.4 GHz
6
7

Mount the Hardware

1
2-24
Remove the Mounting Rail.
With the finished side of the ceiling tile
facing you, use the drill and 1/4-inch
drill bit to drill four holes where you
marked in the B holes in the previous
steps.
Using the mark you made in Step 5 as
the center point, use a one-inch hole
saw to drill out a one-inch hole in the
ceiling tile. This hole is to pass the
Ethernet/LAN cable through the
ceiling to the Access Point.
Put the tile and mounting rail aside.
Perform this step to connect both
adapter plates to the mounting
bracket:
• Remove the adhesive strip from the
adapter plate.
• Orient the adapter plate so the bolts
face the same direction as the shoulder
screws that are already attached to the
bracket.
• Place the bolts through one set of outer
holes on the bracket.
• Press the adapter plate firmly against the
bracket to ensure a strong adhesive
hold.
DRAFT - 03 JUN 2022 13:32