Table of Contents
Advertisement
3
4
Smart-hopping 2.0 Access Point 1.4 GHz Installation Guide
Place the mounting rail against the
finished side of the tile, aligning the
center of the mounting rail with the
marks you made on the tile.
Make sure the side of the rail labeled
Cable Access
Flush Mount
faces you.
Place four marks on the inner edge of
the ceiling tile at the points where the
arrows of the
<--Flush Mount Cutout-->
markings on the mounting rail end.
DRAFT - 03 JUN 2022 13:32
Flush Ceiling Mount (with Cosmetic Ring)
Draw Marks
Draw Marks
2-15
Advertisement
Table of Contents
