Recovery Method; When Problems Occur In A Ccr Software Ini File; When Problems Occur In Ccr Software - Canon CXDI-40G COMPACT Service Manual

2.4 Recovery Method

2.4.1 When Problems Occur in a Ccr Software ini File

The system can be recovered to the last environment status just before the system was
used by users when problems
*1
When the setting data or files are damaged
In this case,
In this case, restoration is possible by copying the Bodyparts folder and all ini files stored
on the floppy disk into d:\ccr, thus overwriting the existing data in it.

2.4.2 When Problems Occur in Ccr Software

When problems occur in files other than ini files for d: \Ccr software other than the OS,
recovery can be accomplished by adding or replacing the relevant files if you can identify
the defective files. Recover Ccr with the following procedure if you cannot identify the
defective files:
1) Copy d: \ccr to a different directory or laptop computer.
2) Delete d: \ccr, and then newly install the CXDI software. (Note)
(Note) The same version of the software must be installed.
3) Copy the following files in Ccr that were copied in Step 1) to d: \ccr
\dtstore (captured images)
\Logs
\White.dcm
\defpix#.dat
\xxxxxx.dp
4) Newly install the optional software (DMW/Gen.communication) if you are using it.
5)
To restore the user operating environment, copy the Body parts folder and all ini files stored
on the floppy disk into d:\ccr, thus overwriting the existing data in it.
6) Perform the settings again that are described in the "Control PC serial number" and
"Setting the imaging unit identification and the number of connecting units" in this
manual "Setting Procedures".
5.Troubleshooting
*1
occur in d:\Ccr software other than the OS.
- 6 -