Communications; Display, Keypad And Leds - GE DTR GEK-106305A Instruction Manual

7.6 COMMUNICATIONS

Enter the hidden menu < 7169 > and set the following communication parameters:
Relay number
Local baudrate
Remote baudrate
Local stop bits
Remote stop bits
1. Request the relay model through the front port, previously checking that the PC communication parameters are
the same as the relay's.
2. Request the relay model through one of the rear ports, previously checking that the PC communication
parameters are the same as the relay's.
3. Request the relay model through the remaining rear port, previously checking that the PC communication
parameters are the same as the relay's.

7.7 DISPLAY, KEYPAD AND LEDS.

1. Press the following keys in the shown order, and check that the display shows the attached messages:
2. Press 6 to 0 number keys, until you complete number 6543210.
3. Press the CLR key, and check that every time it is pressed, the last digit of the number disappears.
4. Press keys 2, ENT, END, 1/Y, and check that the displayed message is SETTINGS CHANGE EXECUTED.
GEK-106305A
7. ACCEPTANCE TESTS
1
19200
19200
1
1
KEY MESSAGE
SET SEE PROTECTION SETTINGS
CLR DTR GENERAL ELECTRIC
INF STATUS
ENT MODEL
UP arrow DATABASE
DOWN MODEL
arrow
CLR STATUS
CLR DTR GENERAL ELECTRIC
ACT SET DATE/TIME
CLR DTR GENERAL ELECTRIC
7169 BAUDRATE
UP arrow NETWORK STOP BITS
DTR Digital Tap Changer Controller 63