Description; Communications; Motor Identification - GE MOTOR MANAGER 2 Instruction Manual

4 SETPOINTS
4.2 S1 CONFIGURATION
This page is used to enter all information about the configuration of the MM2 and the motor being
protected by the MM2. Setpoints Page 1 is divided into eight sections, COMMUNICATIONS,
MOTOR IDENTIFICATION, STARTER, CT / VT INPUTS, THERMISTOR, FAULT MODE, STATIS-
TICS, PROGRAMMABLE MESSAGE and PREFERENCES.
PATH: SETPOINTS M S1: CONFIGURATION M COMMUNICATIONS

COMMUNICATIONS

ADDRESS: OFF
BAUD RATE: 9600
PARITY: NONE
PATH: SETPOINTS M S1 CONFIGURATION MM MOTOR IDENTIFICATION
MOTOR NAME:
MOTOR
MOTOR RATING
OFF kW
HIGH SPEED MOTOR
RATING: OFF kW
SYSTEM SUPPLY:
480 V
GE Power Management
Range: 1 to 255 or OFF, Step: 1
Each MM2 on the same serial communication network must have a
unique address in the range of 1 to 255. Computer software driving the
serial network must be configured to recognize each separate address.
Range: 1200, 2400, 4800, 9600, 19200
Selects the data transfer rate for Modbus serial communications.
Range: NONE, ODD, EVEN
This setpoint determines what type of parity checking is used when com-
municating to the MM2.
Range: 20 ASCII characters
Enter a motor name that will appear in the actual values message
A1: DATA \ MOTOR DATA \ MOTOR STATUS.
Range: 0.3 kW to 1100 kW or OFF; Step: 0.1 kW
Enter the motor rating (or low speed motor rating for two speed starters)
in kWs on this line. This message is for reference only and does not
affect operation of the MM2.
Range: 0.3 kW to1100 kW or OFF, Step: 0.1 kW
Enter the high speed motor rating (applicable for Two Speed starters
only) in kWs on this line. This message is for reference only and does
not affect operation of the MM2.
Range: 110 V to 600 V; Step: 1 V
Enter system supply voltage on this line. This message is for reference
only and does not affect operation of the MM2.
MM2 Motor Manager 2
4.2 S1 CONFIGURATION

4.2.1 DESCRIPTION

4.2.2 COMMUNICATIONS

4.2.3 MOTOR IDENTIFICATION

4
4-3