Replacing Modules; Figure 3.18 Removing Cable - Samsung OfficeServ 7200 Installation Manual

OfficeServ 7200 Installation Guide
5

Replacing Modules

If the OfficeServ 7200 system fails to operate normally due to an error on the power
supply module, control module or interface module, replace the module with a new one.
The procedure for replacing a module is as follows:
1. Switch off the power to the chassis (Fig. 3.17).
2. When replacing a control module, first remove the extension cable connecting
the MCP module to the LCP module. Also, remove all cables connected to the
module to be replaced (Fig. 3.18).
© Samsung Business Communications
Removing Cables
Replace a module only after removing all cables connected to the module.
Figure 3.17 Turning Off the Chassis Power
LINK1
LINK3
Figure 3.18 Removing Cables
CHAPTER 3. Mounting and Replacing Modules
Page 3-13