Installing In A Rack; Precautions; Required Items - Samsung OfficeServ 7200 Installation Manual

CHAPTER 2. Installing Chassis
3

Installing in a Rack

This section describes how to install the OfficeServ 7200 chassis inside a 19-inch rack
3.1

Precautions

The rack should be a standard electric equipment rack.
When using an enclosed-type rack, check if the rack is properly ventilated. Vents
should be equipped on the side of the rack and fans should be attached to draw
cool air into the rack.
Take special care with an enclosed-type rack that has vents on top since hot air
coming out of the vent may enter the intake vent of a system installed above the
rack.
When using an open rack, do not block the entrance of a port or fan.
3.2

Required Items

A mid-sized crosshead screwdriver
A bracket and three screws for attaching
to the chassis
Two brackets and six screws for
attaching to the rack
Two screws for fastening
Page 2-2
OfficeServ 7200 Installation Guide
Figure 2.1 Items Required for
Rack Installation
© Samsung Business Communications