Notes On Remote Maintenance Service; Problems With Xcp And Workarounds; Problems That Might Occur With Xcp 2043 And Workarounds - Fujitsu M10 Product Notes

described in evp(3openssl).

Notes on remote maintenance service

Note - Enhanced Support Facility (ESF) and Remote Customer Support System (REMCS) are
not supported on SPARC M10 systems sold outside of Japan.
This section describes notes when using the remote maintenance service. See
Enhanced Support Facility User's Guide for REMCS for how to set and use REMCS.
Before setting the remote maintenance service
To use the remote maintenance service with SPARC M10 Systems, you must perform
settings for the REMCS agent function by using XSCF Web. In addition, the REMCS
agent uses timezone information of XSCF. Perform the following settings in advance
with the XSCF shell:
Setting necessary for using the XSCF Web, such as enabling the HTTPS setting
■
Setting the timezone for XSCF
■
After completing the above settings, perform settings for the REMCS agent function
by using the XSCF Web.
See SPARC M10 Systems System Operation and Administration Guide for details of the
XSCF Web settings and timezone settings.
Timezone for the REMCS agent function
The REMCS agent uses the timezone currently set for the system. For this reason,
when you change the system timezone with XSCF, set the periodical connection
schedule again to update the information of REMCS center.

Problems with XCP and Workarounds

This section describes problems with XCP and workarounds for each version.
Problems that might occur with XCP 2043 and
workarounds
The following table shows problems that might occur with XCP 2043 and workarounds
for them.
Chapter 3 Information on Software 15