in the arrow direction to remove it. At this time, do not pull out the crossbar
cable by holding the cable part. If you pull the cable part, the connector is not
unlocked completely, which may cause a damage.
Figure 8-34
Removing crossbar cable (electrical)
Installing Crossbar Cable (Electrical)
2.
Connect two crossbar cables (electrical) to each cabinet.
Hold the connector part of the crossbar cable (electrical), and insert it straight
into the opening. Do not hold the cable part when inserting the cable.
Removing Crossbar Cable (Optical)
1.
Remove two crossbar cables (optical) from SPARC M10-4S.
Hold the tab (A in the figure) of the crossbar cable (optical), and pull it straight
Chapter 8 Contents of Revision of Documentation
A
113