Fujitsu M10 Product Notes page 166

Figure B-25
C
B
■
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2043 ･ October 2013
154
Installing cable (cable (PWR))
For the cable (SIG), install the connector that has a threaded hole on itself
to the terminal board.
Use the screw that has been removed from the same location before. Tighten
the screw with a Phillips screwdriver (bit No. 1). When installing the
connector, orient the connector so that the dot mark (A in the figure) shown in
Figure B-26 is to the left.
A