Contents Of Revision Of Sparc M10 Systems System Operation And; Administration Guide - Fujitsu M10 Product Notes

Contents of Revision of SPARC M10
Systems System Operation and

Administration Guide

This section describes the contents of revision of the SPARC M10 Systems System
Operation and Administration Guide.
Table 8-5 Contents of revision of SPARC M10 Systems System Operation and Administration Guide
Section number
11.2.2
12.2.10
18.1.3
Appendix A
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2043 ･ October 2013
118
Contents of revision
The method for specifying a command described in Step 2 in "11.2.2 Setting
OpenBoot PROM environment variable in control domain" will be changed as follows:
XSCF> setpparparam -p 0 -s boot-script "setenv auto-boot? true"
The procedure for re-enabling a hardware RAID volume in SPARC M10-4/M10-4S
must be carried out after the replacement of the CPU memory unit (lower), not after
the replacement of the PCI backplane. Accordingly, the opening description in
"12.2.10 Re-enabling a hardware RAID volume" will be corrected as follows.
This section describes how to re-enable a hardware RAID volume after replacement
of the SPARC M10-4/M10-4S CPU memory unit (lower) or SPARC M10-1
motherboard unit.
A part of Step 3 in "18.1.3 Updating firmware" will be changed as follows:
3. Execute the flashupdate command to confirm whether the firmware can be
updated to the new version.
XSCF> flashupdate -c check -m xcp -s 2020
XCP update is started. [3600sec]
0XSCF>
When an end value of the showresult(8) command is 0, the firmware can be updated.
The list of device paths for SPARC M10 systems is added to Appendix A.
For details, see "Device Paths of SPARC
of SPARC M10-4" for SPARC M10-4, and see
SPARC M10-4S.
M10-1" for SPARC M10-1, see
"Device Paths of SPARC
"Device Paths
M10-4S" for