NEC IntraMail 4 System Manual page 15

Step 4 Install the IntraMail PCB
- Plug in the IntraMail PCB as shown below.
■
Step 5
Reinstall the CPU PCB.
Step 6
Power up the system.
Step 7
Verify IntraMail operation.
- After the system restarts, go to any keyset and press
■
Step 8 Replace the cover
- Hook the tabs on the rear of the cover into their associated slots, then push the front cover into place.
- Screw in the 2 captive screws that secure the cover to the cabinet.
IntraMail System Guide
(Figure 7: Installing the IntraMail PCB in DS2000)
Be sure to snap the PCB into the supplied plastic standoffs.
Figure 7: Installing the IntraMail PCB in DS2000
You should immediately log into that extension's mailbox and hear the voice prompt, "You have
no new messages."
(Figure 8: Replacing the DS2000 Cover)
Figure 8: Replacing the DS2000 Cover
Installation
DS2000 Installation
MW .
.
4 Slot Cabinet Shown
Chapter 1: Quick Setup ◆ 5
1