Mitsubishi Electric MELSEC-Q Series User Manual page 165

10 DEVICES
10 - 7
(c) The same input number can be designated for a refresh input and a direct
access input.
If used as a refresh input after being used as a direct access input,
operation will be based on the ON/OFF data read at the direct access input.
X0
DX0
X0
Figure 10.3 Refresh Input & Direct Access Input
POINT
(1) When debugging a program, an input (X) can be set to ON/OFF as described
below.
• OUT Xn instruction
ON/OFF command
• GX configurator test operation
(2) With the CC-Link, an input (x) can be designated as a destination device for the
• RX refresh (on Basic model QCPU side) by using a CC-Link automatic refresh
setting.
• Refresh destination (Basic model QCPU side) device of link input of
MELSECNET/H
Operation is based on the ON/OFF data read at
the END processing input refresh.
Y10
Direct access input
Operation is based on the ON/OFF
data read at the input module.
Y11
Operation is based on the ON/OFF data read at
the direct access input.
Y12
OUT X1
X1
MELSEC-Q
10 - 7