Table of Contents
Advertisement
1.3.4
POW-MSDCE
This is the DC-48/60V power supply used for GS4000-160E2 and GS4000-320E.
(1) Outer Appearance
As for the LED, see Table 1.3-4.
Cable Clamp
Mounting
Screw
Potential Tap
(Read the
Warning below.)
Figure 1.3-4
(2) LEDs
In the DC-48/60V power supply for GS4000-160E2 and GS4000-320E2, the action status is
indicated by the combination of the two LEDs as shown in Table 1.3-4.
Table 1.3-4
Name
POWER
ALARM
（LED: Green）
（LED: Red）
Power ON
Power OFF
Power OFF
Power ON
Power OFF
Power OFF
Note: There is the possibility that both POWER LED and ALARM LED are powered off depending on the contents of a
trouble.
(3) Accessories
No accessories provided.
*
520-10-026-30X
LEDs
Outer Appearance of POW-MSDCE
WARNING: TO MEASURE THE VOLTAGE AT A DC-POWERED DEVICE, THE END
TERMINAL IS ATTACHED TO POW-MSDCE. ONLY TRAINED ENGINEERS OR
MAINTENANCE SERVICE PERSONELL ARE ALLOWED TO MEASURE THE
VOLTAGE. TO AVOID A FIRE OR AN ELECTRIC SHOCK, DO NOT INSERT
SMALL PINS OR PAPER CLIPS INTO THE TERMINAL.
LED Indicators on the POW-MSDCE Front Panel
Action Status
Output voltage is normal.
Output voltage is abnormal.
Power is OFF or the output voltage is abnormal.（Note）
NOTE: DC cables must be prepared by the customers themselves.
GS4000 Installation Guide Revision 4.00
Terminal
Board Cover
Terminal
Board
Circuit
Breaker
Handle
1-37
Advertisement
Table of Contents
