Table of Contents
Advertisement
GS4000 Installation Guide Revision 4.00
In the following two cases, do not turn off power to the device until the STATUS LED of
•
BCU changes from "Green (blinking)" to "Green (ON)". Otherwise, the device might be
damaged:
Initial power entry (with the memory card mounted) after the device is unpacked or
During a software update.
•
When moving the device, do not hold the handle of a power supply. These handles are
not intended for this purpose and could break off, causing the power supply and the
device to fall, which could cause injury to you. The device itself could also be damaged,
which could cause a shock or fire hazard.
•
Do not install optional modules from a GR4000 or GS4000 into devices other than
another GR4000 or GS4000. Doing this could cause a fire or an electric shock.
CAUTIONS
•
Move the device carefully. Before doing so, unplug the power and other cables. Failure
to follow this warning may damage the device or cables, or could cause a fire or an
electric shock.
•
Do not step on the device, place heavy objects on it, or lean against it. Doing so could
cause the device to be damaged directly or indirectly from a fall.
•
The weight of each optional component for the GR4000 or GS4000 is listed in the table
below. Be careful not to injure yourself when handling these components.
Model Type
AC Power Supply for GR4000-80E1, GR4000-160E1, GS4000-80E1, and GS4000-160E1
AC Power Supply for GR4000-320E (AC) and GS4000-320E (AC)
DC Power Supply for GR4000-80E2/ GS4000-80E2
DC Power Supply for GR4000-160E2, GR4000-320E (DC), GS4000-160E2,
and GS4000-320E (DC)
Basic Control Unit (BCU)
Packet Routing Unit (PRU for GR4000) or Packet Switching Unit (PSU for GS4000) with
NIFs installed
High Port Dencity PSU- Integrated NIF
•
When detaching the AC power supply from GR4000-320E (AC) and GS4000-320E (AC),
or the DC power supply from GR4000-160E2, GS4000-160E2, GR4000-320E (DC) and
GS4000-320E (DC), do it by holding its handle firmly, so that it cannot drop
accidentally and cause injury. Comply with the instructions written on the caution label
attached on the device.
•
Do not install the device in a dusty or humid location. Doing so may cause a fire or an
electric shock.
•
Condensation may form on the surface and inside of the device if it is moved from a cold
to a warm location. Using the device in this condition may cause a fire or an electric
shock. After moving the device between two locations with a large temperature variation,
let the device stand for a few hours before using.
•
Do not put your hands into the device when it is operating, since you could be injured
by a moving part.
•
Do not put the power cable near a heater, since it could melt the power cable casing a
fire or an electric shock.
xiv
Approximate Weight in kg
(lbs)
5 (11)
10 (22)
4 (9)
7 (15.5)
4 (9)
5 (11)
5(11)
520-10-026-30X
Advertisement
Table of Contents
