Mitsubishi Electric KD Series User Manual page 51

3-2-1 Preparation by users
① DC5V power cable
Following cable connectors are recommended.
Housing : DAU-15S-F0R(JAE）
Contact socket
CIS connector is DAU-15P-F0R (JAE), and the contact pin
is 030-50635 (JAE)
Pin assignment of CIS connector is as shown below
Pin
L1
No
V1 V1
1
2
3
4 +5V +5V
5
6
7
NC NC
8
9
10
11
12 GND GND
13
14
15
TM-XH719C
3-2 Preparation
: 030-50634(JAE）
V3
Name
L2 L3
V3 V1 V3
+5V
(NC)
+5V
+5V +5V
+5V +5V
(NC) (NC)
NC NC NC
GND
(NC)
GND
GND GND
GND GND
(NC) (NC)
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
"NC" on the pin assignment means no connection. Therefore,
the same pin assignment of V1 can be applied with the pin
assignment of V3.
Set the pairs of +5V and GND as follows, when you connect
pins.
1 pin and 9 pin, 2 pin and 10 pin, 3 pin and 11 pin,
4 pin and 12 pin, 5 pin and 13 pin, 6 pin and 14 pin,
7 pin and 15 pin
【 Reference 】CIS internal connections (L1）
1 2 3 4
Symbol
Image processing
画像処理基板
VDD
board
【Remarks】
When you use a cable in the field as the power cable, confirm
the connection and the cable length and standard carefully.
Cable resistance 120mΩ or less between the power supply
and CIS is recommended.
(Cable standard AWG22： approx. 2m, AWG20： approx. 3m,
GND
AWG18： approx. 5m)
5 6 7 8 9 10 11 12 13 14 15
Image processing
画像処理基板 Ｉ/Ｆ基板 I/F board
board
V1
Control board 制御基板
51