Mitsubishi Electric KD Series User Manual page 13

1-3-1 Conditions - CE mark certification
1. KD6R367CX (L1 type）
KD6R367CX
V1 Ａ
V2
Ｂ
D1◎
Ｃ
D2
Ｃ
D3
Ｃ
D4
Ｃ
TM-XH719C
1-3 CE marking
In order to make this product complied with CE mark, attach ferrite cores on the
cables as shown on the left diagram. The ferrite cores enable to reduce the noise
emission from the cables.
Recommended ferrite cores are shown below.
Ferrite core A：
Ferrite core B：
DC5V Power
Ferrite core C：
DC24V Power
Port 1
1. KD6R367CX (L1 type）
Port 2
Port 3
Port 4
Frame
grabber board
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
RFC-20, KITAGAWA INDUSTRIES CO.,LTD
RFC-H13, KITAGAWA INDUSTRIES CO.,LTD
RFC-20, KITAGAWA INDUSTRIES CO.,LTD
Attach ferrite cores as described in below.
- Cable between V1 connector and 5V power supply: One Ferrite core A (2 turn)
- Cable between V2 connector and 24V power supply: One Ferrite core B (2 turn)
- Cables between Connector D1, D2, D3, and D4, and Frame grabber:
One Ferrite core C for each cable (1 turn)
13