How To Wire The One-Touch Connector Plug - Mitsubishi Electric AJ65VBTCU-68DAVN User Manual

7. HOW TO WIRE THE ONE-TOUCH CONNECTOR PLUG

This section describes the way to wire the one-touch connector plug.
Refer to the AJ65VBTCU-68DAVN Digital-Analog User's Manual for
more information on the types and specifications of the one-touch
connector plugs which conform to the AJ65VBTCU-68DAVN.
(1) Cable termination work
Do the following work on the cable terminations of the
communication that are inserted into the one-touch connector
plugs.
1. Cut the outer insulation layer.
3. Cut the aluminum tape and Braid.
1. Cut the outer insulation layer.
• Where possible, round the tip that was cut with nippers or like.
• Do insulation work as necessary on the area of the shield that will not
Communication cable termination work
DA (Blue)
DB (White)
DG (Yellow)
Drain wire
Termination work for analog output cable
Point
If the section of the cable to be inserted is not round, the cable may be
caught at any point and not go far enough.
be inserted into the one-touch connector plug.
2. Separate the shield and drain wire and cut the
shield.
4. Stretch the drain wire and twist it from the base.
(3cm in length, 7 times or more)
3cm
2. Cut the ends of shielded wires to make them
adequate in length.
15
Drain wire
Shield wire
DA (Blue)
DB (White)
DG (Yellow)
Drain wire (20AWG)
V+
COM