Table of Contents
Advertisement
(Continued)
Setting and Adjusting Surround Mode
Adjust the Volume for Each
Speaker
1
Press
to select "SURR" (Sur-
round Speaker) or "SUBWFR"
(Sub-woofer).
• "SUBWFR" can only be selected when
playing back a multi-channel DVD with a
sub-woofer audio signal.
2
Select
or
volume.
Adjust the volume between -6 to +6.
• It will return to sound source display in a
few seconds.
NOTE
• In the following situations, "SUBWFR" cannot be
adjusted.
• "SUB WFR" is set to "OFF" in "Other Settings"
on the right.
• The sound source with stereo sound is played.
• The sound source is DVD/CD and the disc is
stopped.
39
to adjust the
For the locations of remote control
buttons, refer to page 38.
Other Settings
1
Press
.
2
Select a setting item by pressing
or
.
Adjust the volume balance of the front
speakers.
Set whether a sub-woofer is to be used.
Set the decode mode for Digital 1
Terminal.
Set the decode mode for Digital 2
Terminal.
3
Press
to set or adjust the
level.
BAL:
Turning down the volume of the left or right
speaker. To turn down the volume of the right
speaker, press
(R-1-R-21), to turn down the
volume of the left speaker, press
The volume level changes each time the button is
pressed. When the balance is right, it displays
"CENTER".
SUB WFR:
When a sub-woofer is connected to the unit, select
"ON".
When a sub-woofer is not connected, select
"OFF".
DEC1, 2:
This allows you to set to the decode mode when
external equipment connected to Digital 1 or 2
uses Dolby Digital or DTS, or when an equipment
such as a BS digital tuner is connected to Digital 1
or 2. It is helpful in the following situations:
• When the sound is not audible at the beginning
of the playback.
• When noise is heard when selecting a chapter.
AUTO/PCM:Normally this mode should be
selected.
DTS:
This mode should be selected when
the sound is DTS. Other sounds than
DTS are not heard.
• It allows you to return to source (sound source)
display a few seconds later.
(L-1-L-21).
Advertisement
Chapters
Table of Contents
