Starting The Program; Progress Of Program; Changing The Program After The Program Has Started; Auxiliary Functions - Blomberg DV 16540 Owners And Installation Manual

Starting the Program

1. Press the "Start/Pause/Cancel" button to
start the program.
2. The ìStart/Pause/Cancelî button will light up
to indicate that the program has started.

Progress of program

Progress of a running program is shown
through the program follow-up indicator.
At the beginning of each program step, the
related lamp will light up and the lamp of the
completed step will turn off.
"Drying":
- Drying level will be illuminated during the
whole drying process until the dryness
reaches "Damp Dry / Ready to Iron".
"Damp Dry / Ready to Iron":
- Lamp lights when the dryer reaches the
"Damp Dry / Ready to Iron" step and remains
lit until the next step.
"Regular Dry / Ready to Wear":
- Lamp lights when the dryer reaches the
"Regular Dry / Ready to Wear" step and
remains lit until the next step.
"End / Anticreaseî":
- The lamp lights when the program comes
to an end and the anti-creasing function is
activated.
C
If more than one lamp lights or flashes
constantly, it means that there is a
malfunction or a failure (Please see
ìTroubleshootingî).
Changing the program after the
program has started
Press and hold the ìStart/Pause/Cancelî
button for around 3 seconds to ìCancelî the
program currently running.
Select another program by rotating the
program knob.
Press the "Start/Pause/Cancel" button again
to start the new program.
C
The program which is selected first will go
on even if the program selector knob is
moved and another program is selected
while the dryer is operating. You must
cancel the current program to change the
drying program.
A
As the inside of the dryer will be
excessively hot when you cancel the
program when the dryer is running,
activate the ventilation program to cool it
down.
A
If the dryer is stopped during any drying
program, and if the position of the
program selector knob is changed, a
tone will be heard (if the ìCancel Audio
Warningî function is not selected). The
dryer will not start even if the ìStart/
Pause/Cancelî button is pressed, unless
the program selector knob is returned to
the initial program. The paused program
must be cancelled in order to change the
drying program.
Adding/removing laundry in stand-by
mode
In order to add or take out laundry after the
start of the program;
1. Press the ìStart/Pause/Cancelî button to
switch the dryer to ìPauseî mode. the drying
process will stop.
2. Open the door at the Pause position and
close it again after adding or taking out
laundry.
3. Press the "Start/Pause/Cancel" button to
restart the program.
C
Laundry may be added or taken
out during a drying process, but
interrupting drying continuously will
extend the program's time and increase
energy consumption. Therefore, it is
recommended to add all laundry before
the drying program is started.

Auxiliary functions

Cancel Audio Warning Signal
Your dryer will send out a tone when the
program comes to an end. If you do not want
to hear this, you need to press the ìCancel
Signalî button. The relevant lamp will light
when this button is pressed and the tone will
not activate when the program ends.
C
You can select this function either before
or after the program starts.
18 - EN