Troubleshooting - Blomberg DV 16540 Owners And Installation Manual

7

Troubleshooting

Problem Cause
Drying process Lint filter may not have been
takes too long. cleaned.
* It may not plugged in.
* The loading door may be ajar.
Dryer does not * Program may not be set or the
switch on or the "Start/Pause/Cancel" button may
program does not have been pressed.
not start. Dryer * "Childproof lock" may be
does not start activated.
when set. * The condenser cover on models
with a condenser may not be
closed securely.
Program is
* The loading door may be ajar.
interrupted for
* Electricity may be cut off.
no reason.
Laundry has
* A program not suitable for the
shrunk, become
laundry type might have been
felted or has
used.
deteriorated.
Drum light does
not come on. * The dryer may not have been
(for models started using the On/Off button.
equipped with a * Bulb may have burned out.
lamp)
* The 2-hour anti creasing
"End /
program to prevent laundry
Anticrease" LED
from wrinkling may have been
flashes.
activated.
"End /
Anticrease" LED * Program has come to an end.
is on.
"Filter cleaning" * Lint filter may not have been
LED flashes. cleaned.
* A heat sensor failure has
The "Drying"
occurred. dryer ends the program
LED flashes.
without heating.
For products equipped with a condenser
* Water tank may be full.
"Water tank"
* Anti-creasing program might be
warning LED on.
running.
"Condenser
* Condenser may not have been
cleaning" LED
cleaned.
on.
A
Call an authorized service if the problem persists.
Explanation / Solution
* Clean the lint filter.
* Make sure that the dryer is plugged
in.
* Make sure the loading door is
properly closed.
* Make sure the program has been set
and it is not in "Pause" mode.
* Deactivate the childproof lock.
* Make sure the condenser cover and
the red lock is closed securely.
* Make sure the loading door is
properly closed.
* Press the "Start/Pause/Cancel"
button to start the program.
* Dry only the laundry which is suitable
for drying in the dryer. First check the
labels on the clothes.
* Select a program a suitable low
temperature setting for the laundry
type to dry the clothes.
* Make sure the dryer is On.
* Call the authorized service to replace
the bulb.
* Turn off the dryer and take the
laundry out of the dryer.
* Turn off the dryerand take the laundry
out of the dryer.
* Clean the lint filter.
* Turn off the dryer and remove the
laundry. Call the authorized service.
* Drain the water from the water tank.
* Clean the condenser.
23 - EN