Type Of Detectors = Type Of Zone Line Input; Input States - Panasonic EBL512 G3 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01472 Rev: -
6.2.1
6.2.1.1
6.2.1.2
6.2.1.3
6.2.1.4
6.2.1.5
6.2.2
6.2.2.1
Planning Instructions Fire alarm system EBL512 G3, United version 2.7.x
Each zone line input has to be programmed via Win512 version
2.7.x regarding:

Type of detectors = Type of zone line input, depending on
detectors, etc.

Alarm at short circuit / No alarm at short circuit

Zone number (address optional)

Fire alarm delay or No fire alarm delay

Text (Alarm text – if you wish)

Alert annunciation & time channel

Disablement & time channel

Two unit dependence

Number of alarm points
The terminals support a wire size up to 1.13 mm

Type of detectors = Type of zone line input

Each input shall be selected as Not used or one of the following types
/ modes.
Conventional detector loop = Zone line input (EOL
capacitor)
This type is normally used.
consumption since the end-of-line device is a capacitor, 470 nF (±10
%). Max. allowed cable resistance is 50 ohm. Max. allowed cable
capacitance is 50 nF. Total detector current consumption < 1.5 mA.
Alarm on short-circuit = Alarm at short-circuit
Like the "Conventional detector loop" but short-circuit on the zone
line will generate a fire alarm instead of a fault, i.e. used for old types
of detectors.
Alarm from control unit
This option cannot be used for an EBL512 G3 control unit.
EX zone line input (EOL resistor)
This option is not available for an EBL512 G3 control unit.
Zone line input (EOL resistor)
This option is not available for an EBL512 G3 control unit.

Input states

Each input will be in one of six different states.
Normal state
The normal zone line input state, i.e. no alarm, no fault, etc. and the
nominal voltage is 24 V DC
reached / activated.
14
Allowed voltage 15-28 V DC.
2
It has the lowest zone line current
14
. From this state any other state can be
29
(1.2 mm).