Control Unit / Tlon Network; The Tlon Network; Single Tlon Network / Redundancy In Distributed System - Panasonic EBL512 G3 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01472 Rev: -
4
4.1
4.2
Planning Instructions Fire alarm system EBL512 G3, United version 2.7.x

Control Unit / TLON Network

The TLON network

In a mixed system, up to 30 control units (EBL512 G3 United
version 2.7.x and EBL512 version 2.7.x) can be connected in a TLON
Network. At least one has to be an EBL512 control unit.
In a TLON Network each control unit works independent but has
nevertheless total access to all information in the system.
NOTE!
In a system with two or more control units in a TLON Network, pay
attention to the following:

A zone must not be distributed over the system, i.e. all alarm
points in a zone have to be connected to one c.i.e.

When the "Fire door closing" function is used, the alarm points
and their "belonging" output must be connected to the same c.i.e.

When the interlocking function is used, the input, the output and
the Interlocking Combination (area-point) must be in / connected
to one c.i.e. An input and an output can only be used in one
Interlocking combination.

When the AAF function is used, all devices within the same AAF
zone must be connected to the same c.i.e.
Single TLON Network / Redundancy in
distributed system
The EBL system can be build up as a single TLON Network system or
a Redundancy in distributed system.
In the single TLON Network, one TLON connection board
(1590/5090) has to be plugged in each control unit.
A fault in a TLON Network generates the following fault:
FAULT: Control unit xx has no contact
with control unit xx
NOTE!
For highest security in a mixed system the function Redundancy in
distributed system can be used in a system with a TLON Network.
One EBL512 control unit has to be the "master" unit and the other
control units in the system are "slave" units that are connected to the
18