Required Jigs - Yamaha YSP10 Service Information

13.2. Required Jigs

This section describes required jigs which are necessary for adjustment.
Adjustment of the lighting conditions for the PCB camera, mask camera and inspection camera

Use light gray sides of the following lighting jigs.
Tool appearance and
features
Two-tone gray
No 3mm hole
No part number label
Two-tone gray
3mm hole
Part number label on tool's
side
17mm square
Mono-tone gray
Two- or mono-tone gray
Part number label
11, 17 or 35mm square
Chamfered on one corner
Two- or mono-tone gray
Part number label
11, 17 or 35mm square
Chamfered on two corners
Part number
・KM1-M8806-00
・KM1-M8806-10
・KM1-M8806-11
See the tool's label for
identification.
・KGT-M8806-00
・KHW-M8896-A0
(two-tone 35mm square)
・KHW-M8806-B0
(mono-tone 17mm square)
・KHW-M8806-C0
(mono-tone 35mm square)
・KHW-M8806-D0
(mono-tone 11mm square)
・KMC-M8806-A0
(two-tone 35mm square)
・KMC-M8806-B0
(mono-tone 17mm square)
・KMC-M8806-C0
(mono-tone 35mm square)
・KMC-M8806-D0
(mono-tone 11mm square)
SI1906002E-001=YSP10 installation and adjustment procedures
63/120
Service Information
CalibSm setting
designation
KM1-M8806-0XX
KM1-M8806-1XX
KGT-M8806-0XX
KHW-M8806-XXX
KMC-M8806-XXX
For Service Engineers
Remark
KM1-M8806-11
KHW-M8806-C0
KMC-M8806-C0