Confirm And Connect The Solvent Tank; Confirm The Solvent Tank Condition; Connect The Solvent Pump Joint And The Production Preparation - Yamaha YSP10 Service Information

5. Confirm and connect the solvent tank

5.1. Confirm the solvent tank condition

If the machine is shipped abroad (other than Japan), the cleaning solvent tank hoses are disconnected.
If a yellow ribbon is tied on the following position of the cleaner unit, connect those hoses to the solder
pump joint by the procedures described below.
Note
As to the machines to be exported, the solvent tank is filled up with water and the joints are
detached.
Front side of the solvent pump

5.2. Connect the solvent pump joint and the production preparation

Connect the solvent pump.
Perform the procedures from Step3 and the following after power and air are supplied.
Note
When the machine is shipped abroad(other than Japan), the solvent pump is filled up with water
and the joint is detached. The water inside the pump can be spilled over upon connecting the joint,
so put the waste cloth or so under the joint to prepare the water spilling.
Connect the joint at the solvent pump inlet.
Remove the yellow ribbons tied to the joint and connect the solvent pump joint.
Positions of yellow ribbons
Front side of the cleaner nozzle
SI1906002E-001=YSP10 installation and adjustment procedures
21/120
For Service Engineers
Service Information