Lenovo ThinkSystem D2 Manual page 210

User Action:
1. Remove A/C from the server and reseat all drives, backplanes, RAID adapters, expanders (if any), and
cables.
2. Ensure device firmware is at the latest level.
3. Retry the test.
4. If the problem persists, contact technical support.
• FQXPMSD0005M: self-test completed having the servo (and/or seek) test element of the test failed.
Severity: Error
User Action:
1. Remove A/C from the server and reseat all drives, backplanes, RAID adapters, expanders (if any), and
cables.
2. Ensure device firmware is at the latest level.
3. Retry the test.
4. If the problem persists, contact technical support.
• FQXPMSD0006M: self-test completed having the read element of the test failed.
Severity: Error
User Action:
1. Remove A/C from the server and reseat all drives, backplanes, RAID adapters, expanders (if any), and
cables.
2. Ensure device firmware is at the latest level.
3. Retry the test.
4. If the problem persists, contact technical support.
• FQXPMSD0007M: Hard Drive(s) not found
Severity: Error
User Action:
1. Remove A/C from the server and reseat all drives, backplanes, RAID adapters, expanders (if any), and
cables.
2. Ensure device firmware is at the latest level.
3. Verify that the same Error is present in BMC or OneCLI inventory log.
4. Retry the test.
5. If the problem persists, contact technical support.
• FQXPMSD0008M: UEFI is not ready for LXPM to send command to test hard drive.
Severity: Error
User Action:
1. Reboot system and run the test again.
2. If this message is still reported, run the latest version of SMART tool on OS which is open source tool
and could be downloaded from website to check hard drive status.
3. If the problem persists, contact technical support.
• FQXPMSD0009M: Device error detected when LXPM sent a test command to a hard drive.
206
ThinkSystem D2 Enclosure, Modular Enclosure, Modular Enclosure for 6U Configuration and ThinkSystem SD530 Compute
Node Messages and Codes Reference