Lenovo ThinkSystem D2 Manual page 202

User Action:
1. Restart BMC via supported method and reboot the system.
2. Perform AC reset.
Note: When performing AC reset, after powering off AC, wait several seconds before powering on
AC. After AC power is restored, power on the host system.
3. Retry the export of BMC setting.
4. If the problem persists, contact technical support.
• FQXPMCL0011I: Import bmc settings successfully.
Severity: Info
User Action:
Information only; no action is required.
• FQXPMCL0011K: Failed import bmc settings.
Severity: Warning
User Action:
1. Ensure BMC version is the same between source and target.
2. Restart BMC via supported method and reboot the system.
3. Perform AC reset or virtual reseat.
Note: When performing AC reset, after powering off AC, wait several seconds before powering on
AC. After AC power is restored, power on the host system.
4. Retry the import of BMC setting.
5. If the problem persists, contact technical support.
• FQXPMEM0001M: Unable to locate LXPM firmware image
Severity: Error
User Action:
1. Restart BMC via supported method and reboot the system.
2. Reflash the LXPM.
3. Perform AC reset or virtual reseat.
Note: When performing AC reset, after powering off AC, wait several seconds before powering on
AC. After AC power is restored, power on the host system.
4. If the problem persists, contact technical support.
• FQXPMEM0002I: LXPM firmware image found. Starting LXPM
Severity: Info
User Action:
Information only; no action is required.
• FQXPMEM0003I: LXPM has exited. Control returned to UEFI
Severity: Info
User Action:
198
ThinkSystem D2 Enclosure, Modular Enclosure, Modular Enclosure for 6U Configuration and ThinkSystem SD530 Compute
Node Messages and Codes Reference