List Of Uefi Events - Lenovo ThinkSystem D2 Manual

Table 3. Events organized by severity (continued)
Message String
Event ID
FQXSFPU0015K A processor stepping mismatch has been detected for one or more
processors.
FQXSFPU0016N A processor within the system has failed the BIST.
FQXSFPU0017G A processor microcode update failed.
FQXSFPU0018N CATERR(IERR) has asserted on processor [arg1].
FQXSFPU0019N An uncorrectable error has been detected on processor [arg1].
FQXSFPU0027N System uncorrectable error has occurred on Processor [arg1] Core
[arg2] MC bank [arg3] with MC Status [arg4], MC Address [arg5], and
MC Misc [arg6].
FQXSFPU0030N A firmware fault has been detected in the UEFI image.
FQXSFPU0031N The number of POST attempts has reached the value configured in F1
setup.The system has booted with default UEFI settings. User
specified settings have been preserved and will be used on
subsequent boots unless modified before rebooting.
FQXSFPU0034L The TPM could not be initialized properly.
FQXSFPU4056M TPM/TCM card is changed, need install back the original TCM/TPM
card which shipped with the system.
FQXSFSM0008M Boot permission timeout detected.

List of UEFI events

This section lists all messages that can be sent from UEFI.
• FQXSFDD0001G: DRIVER HEALTH PROTOCOL: Missing Configuration. Requires Change Settings
From F1.
Severity: Warning
User Action:
Complete the following steps:
1. Go to F1 Setup > System Settings > Settings > Driver Health Status List and find a driver/controller
reporting Configuration Required status.
2. Search for the driver menu from System Settings and change settings appropriately.
3. Save settings and restart the system.
4. If the problem persists, collect Service Data logs.
5. Contact Lenovo Support.
• FQXSFDD0002M: DRIVER HEALTH PROTOCOL: Reports 'Failed' Status Controller.
Severity: Warning
User Action:
Complete the following steps:
1. Reboot the system.
2. Reflash the adapter firmware.
Severity
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
. 159
Chapter 4 UEFI events