Front Bearing Carrier Installation - Polaris GENERAL 2016 Service Manual

FINAL DRIVE

FRONT BEARING CARRIER INSTALLATION

1. Install drive shaft axle through the backside of the
bearing carrier.
2. Install the upper and lower ball joint ends into the
front bearing carrier.
3. Install NEW pinch bolts and nuts. Torque to
specification.
TORQUE
Ball Joint Pinch Bolts:
42 lb-ft (57 Nm)
4. Install the steering tie rod end onto the front bearing
carrier. Torque the
specification.
TORQUE
Tie Rod End Fastener:
15 lb-ft (20 Nm)
5. Apply Anti-Seize to drive shaft axle splines.
7.42
tie rod end fastener
6. Install front wheel hub assembly
e
, Install washer with domed side out. Hand tighten
the castle nut.
2016–2017 models have two cone washers
7. Install NEW brake caliper mounting bolts and torque
to specification.
Front Caliper Mounting Bolts:
to
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
mounting bolts upon assembly.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
w
, and cone washer
NOTICE
TORQUE
30 lb-ft (41 Nm)
CAUTION
© Copyright Polaris Industries Inc.