Front Bearing Carrier Installation - Polaris RZR 900 2017 Service Manual

FRONT BEARING CARRIER
INSTALLATION
1. Install drive shaft axle through the backside of the
bearing carrier.
2. Install the upper and lower ball joint ends into the
front bearing carrier.
q
3. Install new pinch bolts and nuts. Torque to
specification.
TORQUE
Ball Joint Pinch Bolts:
42 ft-lb (57 Nm)
4. Apply Anti-Seize to drive shaft axle splines.
5. Install front wheel hub assembly
and hand tighten the castle nut. Install washers with
domed side out.
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
© Copyright Polaris Industries Inc.
6. Install new brake caliper mounting bolts and torque to
specification.
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
7. Install the steering tie rod end
bearing carrier.
Refer to the photo below to ensure proper placement of
w w
, cone washers ,
8. Torque the tie rod end fastener
install a new cotter pin.
FINAL DRIVE
TORQUE
Front Caliper Mounting Bolts:
30 ft-lb (42 Nm)
CAUTION
mounting bolts upon assembly.
r
onto the front
NOTICE
the tie rod end.
t
to specification and
TORQUE
Tie Rod End Fastener:
30 ft-lbs (41 Nm) + 90°
8
8.5