Rear Drive Shaft Installation - Polaris GENERAL 2016 Service Manual

FINAL DRIVE
6. Remove the fasteners
carrier to the upper and lower control arms.
7. With a short, sharp jerk, remove drive shaft from the
transmission splines.
7.32
r
securing the rear bearing

REAR DRIVE SHAFT INSTALLATION

1. Install NEW spring ring on drive shaft. Apply an anti-
seize compound to the splines.
IMPORTANT
2019 General Models have an O-ring
shaft. Ensure the O-ring is present and not damaged
before installation.
2. Align splines of drive shaft with transmission splines
and reinstall the drive shaft. Use a rubber mallet to
tap on the outboard end of the drive shaft if
necessary.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
A
on the drive
© Copyright Polaris Industries Inc.