Configuration; Configuring The Instrument - ABB SM1000 User Manual

Videographic Recorders
SM1000 and SM2000

3 Configuration

3.1 Configuring the Instrument

Note. Changes to the IP address, subnet mask and default
gateway are implemented only after the instrument has
been restarted. Change the addressing parameters, exit
and save the configuration, wait until the 'Please Wait'
message disappears then power down and restart the
instrument.
– from the 'System Configuration' screen, access
SM1000 only
the Ethernet Module:
– from the 'System Configuration' screen, access
SM2000 only
the Ethernet Module:
Set the IP-address to be assigned to the instrument. The IP
address is used by the TCP/IP protocol to distinguish between
different devices. The address is a 32 bit value expressed with
four values (0 to 255), each separated by a period (.).
The subnet mask is used to indicate which part of the IP
address is for the network ID and which is for the host ID. Set as
'1's each bit that is part of the network ID, e.g. 255.255.255.0
indicates first 24 bits are for the network ID.
IM/SMENET Issue 4
I/O
Modules
Set the IP address for the 'Default gateway' (router, switch etc.)
required to communicate with other networks. This setting may
not be required. The default setting is '0.0.0.0'
The 'FTP User' name and password are used during logon to
enable the FTP server. Access for up to four different users is
provided. These passwords can also be used to allow access to
some functionality provided by the web server.
Enter the name of the user granted FTP access.
Enter the password of the user granted FTP access.
Select whether this FTP user has full access (i.e. the ability to
read, write and delete files) or read-only access.
Note. If a user is given full access via FTP, that user is able
to delete both data and configuration files. This could result
in erroneous operation of the instrument.
Select the level of remote operation access granted to this user:
None – the user is unable to log on to the instrument
remotely using a web browser
Operator – the user can acknowledge alarms and
start/stop totalizers using a web browser
Configuration – in addition to operator functions, the user can
load configurations
instrument's internal clock using a web
browser
3 Configuration
and change the
5