Replacing The Fuses; Maintaining The Headlights - Toro Workman GTX Operator's Manual

Replacing the Fuses

There are 4 fuses in the electrical system; the other
slots are open for options. They are located under the
seat assembly behind a battery on the right side of
the machine (Figure 40).
Main power
Electric relay
USB power point
Headlights
Optional lift kit—open
Horn
Figure 40
1. Fuse block

Maintaining the Headlights

Replacing the Headlight
1. Disconnect the batteries; refer to
the Batteries (page
10 A
2. Open the hood.
20 A
3. Disconnect the electrical connector for the
5 A
harness from the connector of the lamp
assembly
10 A
15 A
30 A
g277605
1. Speed clip
2. Opening in the bumper
3. Adjustment screw
4. Remove the speed clips that secure the
headlight to the headlight bracket
Note:
Retain all parts for installation of the new
headlight.
5. Remove the headlight assembly by moving it
forward through the opening in the front bumper
(Figure 41).
6. Install the new headlight through the opening in
the bumper
Note:
Ensure the adjustment posts are lined up
with the holes in the mounting bracket behind
the bumper.
38
36).
(Figure 41).
Figure 41
4. Headlight
5. Harness electrical
connector
6. Lamp assembly
(Figure 41).
Disconnecting
g277621
(Figure 41).