Toro Workman GTX Operator's Manual page 37

6. Connect the batteries together as shown in
Figure 39 with the battery-interconnect cables
that you removed in step 1.
Connecting the Batteries
1. Ensure that the battery terminals are clean and
free of oxidation.
2. Connect the main positive-battery cable (red)
between the bank of batteries and the machine
(Figure 39).
3. Connect the main negative-battery cable (black)
between the bank of batteries and the machine
(Figure 39).
4. Torque the nuts securing all of the battery cables
until the retainer securely grips the battery.
5. Coat the battery terminals with Toro
battery-terminal protector.
6. Ensure that the rubber boots on each battery
cable are securely seated over the battery
terminals.
7. Insert the key into the key switch and rotate the
switch to the O
8. Lower the cargo bed, rotate the key switch to
the O position, and remove the key.
FF
Storing the Batteries
Charge the batteries fully before placing the machine
into storage. Plug the charger into a wall outlet while
the machine and batteries are in storage. Leave
the charger plugged into a wall outlet and charging
receptacle during storage to ensure that the batteries
stay charged and do not freeze; otherwise, charge the
batteries at least once a month.
Important:
If the machine cannot be plugged
in during storage, fully charge the batteries at
least once a month. The batteries self-discharge
over long periods of time, which may damage the
batteries to the point of being unusable, even if
the batteries are new.
37
position.
N